Sinounique: Cement Production Line Part II
Rotary
Dryer
It
is a rotary dryer that serves to dry the material to a certain humidity. Widely
used in metallurgical industry, material construction, chemical, and mineral
industry. This dryer is able to dry various materials made of various kinds of
materials with simple and reliable operation. Sinounique rotary dryer has
dimensions x length of 1.2 × 8.0m - 3.6 × 28m, and is supported with production
capacity reaching 1.9-76.0 t / h. It is possible to perform production
optimally, but with low fuel consumption.
Rotary
dryers have a section structure consisting of transmission devices, seal rings,
support devices, lifting blades, and rotary bodies. This machine lifting knife
is capable of many things, such as lifting materials, guiding and equating
materials, and so on. This dryer is very efficient to use, even able to reduce
electricity and coal by 10-15%. It is then able to increase production capacity
by 10-15%. This is because the dryer can distribute material evenly on radical
parts. Thus, it can utilize heat energy to the maximum. The material will be
fully in direct contact with the hot air flow. The material will be dried on
the cylinder by interchangeable heat energy between the material and the hot
air cylinder. Thus, it will reduce the moisture level of the dried material.
Air-swept
Coal Mill
It
is a dryer that is often used to reduce the moisture of coal material. It
consists of a machine structure consisting of rotation devices, feeders,
transmission devices, main bearings, lubricant systems, high-pressure start-up
devices, and usage devices. This tool becomes one of the components of the tool
in making coal powder. Air-swept Coal Mill is often used in metallurgical,
chemical, cement making, steam power, and other industries. Sinounique's coal
dryer has a working capacity of 8-43 t/h, allowing for maximum work in the
field. Plus there are three plates on the cylinder that can improve
performance, namely ripple layer plates, double-glazed coating plates, and
sequential snoozing layer plates. Air strokes on the engine are driven by
motors through gears and silencers.
The
working principle of this tool starts by inserting the material into the feeder
device. To dry the material, the hot air (300) will then be inserted through
the airways on the feeding device. Thus, there will be a heat exchange with hot
air, making the material dry. Dry coal will go through the next process, namely
the milling process until the material becomes powdered. Ingredients that have
not been a fine powder will be re-ground until properly correct into a fine
powder.
Post a Comment for "Sinounique: Cement Production Line Part II"